top of page
Search

Measure Coating Thickness on Critical and Difficult Areas

Nov 7
2 min read

Real industrial parts are rarely flat.

A flat test panel is easy to measure.

Production parts are different.

They may contain:

  • Curves

  • Edges

  • Corners

  • Recesses

  • Ribs

  • Flanges

  • Weld seams

  • Narrow surfaces

  • Internal features

  • Complex three-dimensional geometry

These areas are often exactly where coating thickness becomes hardest to control.


The easiest point to measure may not be the most important point

A coating can look acceptable on a large flat surface while the thickness varies significantly elsewhere on the part.

Depending on the application, critical areas may include:

  • An edge where coating builds differently

  • A recessed area with limited powder deposition

  • A flange with changing geometry

  • A curved surface

  • A difficult-to-access underside

  • A narrow structural feature


If these areas are not measured, the production team may have an incomplete picture of the coating condition.


Non-contact measurement creates new possibilities

PaintChecker measures coating thickness without physically contacting the coating surface.

This is especially relevant before curing, when uncured powder cannot be measured using conventional contact-based methods.

The small measurement area can also make it possible to evaluate specific locations on complex parts.

Depending on the application, PaintChecker can be assessed for areas such as:

  • Edges

  • Curves

  • Recesses

  • Corners

  • Ribs

  • Flanges

  • Small local surfaces

Application suitability always depends on the actual geometry, coating, substrate, working distance, and measurement conditions.


Why critical geometry matters in powder coating

Powder does not always deposit uniformly across a complex part.

Geometry, electrostatic effects, spray direction, gun position, and robot path can all influence the local coating thickness.

This means the most difficult areas to coat can also be the areas where measurement information is most valuable.

If those areas are only checked after curing, the process may already be complete before the problem is known.

Pre-cure non-contact measurement can provide an earlier opportunity to investigate the condition.


Improve measurement coverage

The objective is not simply to take more measurements.

It is to measure the locations that matter.

Better measurement coverage can help production and quality teams understand:

  • Where coating thickness varies

  • Which areas are consistently difficult

  • Whether spray settings are appropriate

  • Whether robot paths need adjustment

  • Whether additional powder is actually required

  • Whether a critical area is within the expected range


Fewer blind spots. Better process knowledge.

A single measurement on an easy flat surface may confirm that one location is acceptable.

It does not necessarily confirm that the entire coating process is under control.

By evaluating more representative and critical areas, manufacturers can build a more complete picture of coating performance.

This can support:

  • Better coating-quality confidence

  • Faster troubleshooting

  • Better spray-gun setup

  • Improved robot-path optimization

  • More informed process adjustments

  • Reduced risk of unnoticed local thickness variation


Evaluate the actual part

Complex geometry is application-specific.

The best way to determine whether PaintChecker is suitable is to evaluate the real part.

We recommend testing:

  • The actual coating

  • The actual substrate

  • The real geometry

  • The critical measurement locations

  • The required thickness range

  • The expected production conditions

The goal is simple:

Determine whether the areas that are difficult to coat can also be measured reliably enough to improve the process.


Measure where it matters.

Do not limit coating-thickness control to the easiest surface.

Understand the edges, curves, recesses, and other areas where coating performance may vary most.


Better coverage.Fewer blind spots.More confidence in coating quality.



 
 
 

Recent Posts

See All

Comments


bottom of page